What is the order that the brake bleeder go ya bleed the brake line?

What is the order that the brake bleeder go ya bleed the brake line?
The order to properly bleed the brakes is as follows:
1. Top up master cylinder.
2. Always start at the wheel closest to the master cylinder and work to the furthest from the master cylinder.
3. Open the bleeder nipple on the wheel nearest to the master cylinder.
4. Have an assistant depress the brake peddle and hold it to the floor.
5. Close the nipple.
6. Top up master cylinder and then have assistant release the brake peddle.
7. Open the same nipple again. Have assistant depress the brake peddle and hold.
(Continue this procedure until all air has been pumped out of this section of the brake line and only brake fluid is pumped out.
8. Close the nipple and move to the front wheel on the opposite side.
9. Do the same procedure on this wheel i.e. open nipple, depress brake pedal and hold, close nipple, top up master cylinder, open nipple, depress brake peddle etc.
10. Follow this procedure for the rear wheel nearest to the master cylinder, and finally with the wheel furthest from the master cylinder.
The brake system should be free of air.